A laser head has three main functions. 1: Holding your mirror and lens 2: Keeping your lens free from smoke 3: Blowing air on the cut area to prevent fires, burnt edges and better capacity. […]
For air assist, it´s recommended to go with a air assist head when there is one really good for our machines out there. For pushing air to your laser head you need a air pump. […]
Smoke assist helps your machine in different ways. – Pushes air over the work piece to the back – Helps creating a positive pressure for less strain on the exhaust fan – Keeps optics clear(er) […]
Exhaust fan is almost as important as the laser tube in your machine. Without proper exhaust the fumes, smoke and smell will stay in the room you have the machine. Remember to have the fan […]
The Cohesion3d LaserBoard is one of the best upgrades regarding controller board for your laser machine. Lightburn works perfect with this controller and you are set for advanced engravings and a better work flow than […]
If your machine does not have a mA-meter installed this is the first upgrade you should make for it. With a meter you can keep a eye on the power levels and stay within the […]
The original potentiometer is very limited and tend to break after a while creating problems for your work. Upgrade your pot to a 10-turn potentiometer to get better resolution and better power settings for your […]
A lid switch is a easy security solution to prevent the laser from firing the beam while your lid on the machine is open. Its a very easy product, a micro switch with two cables. […]
Additives to your coolant is important if you want to prolong the life of the coolant. With time algea growth and other micro organisms will flourish in your coolant making it harder to pump, it […]
Adding a extra 24V power supply to take the load off from your laser power supply is a good upgrade. Except from releaving the laser PSU from the power, you will also notice better control […]
This website is owned and maintaned by HP Persson - HawkCan Labs SA