Smoke assist helps your machine in different ways. – Pushes air over the work piece to the back – Helps creating a positive pressure for less strain on the exhaust fan – Keeps optics clear(er) […]
For air assist, it´s recommended to go with a air assist head when there is one really good for our machines out there. For pushing air to your laser head you need a air pump. […]
A laser head has three main functions. 1: Holding your mirror and lens 2: Keeping your lens free from smoke 3: Blowing air on the cut area to prevent fires, burnt edges and better capacity. […]
The Cohesion3d LaserBoard is one of the best upgrades regarding controller board for your laser machine. Lightburn works perfect with this controller and you are set for advanced engravings and a better work flow than […]
Exhaust fan is almost as important as the laser tube in your machine. Without proper exhaust the fumes, smoke and smell will stay in the room you have the machine. Remember to have the fan […]
The original potentiometer is very limited and tend to break after a while creating problems for your work. Upgrade your pot to a 10-turn potentiometer to get better resolution and better power settings for your […]
If your machine does not have a mA-meter installed this is the first upgrade you should make for it. With a meter you can keep a eye on the power levels and stay within the […]
A lid switch is a easy security solution to prevent the laser from firing the beam while your lid on the machine is open. Its a very easy product, a micro switch with two cables. […]
This website is owned and maintaned by HP Persson - HawkCan Labs SA